MAINTENANCE
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 1B-37
Starter Motor
MIE MODELS
WARNING
When performing the following procedure, be sure to observe the following:
• Be sure that engine compartment is well ventilated and that no gasoline vapors
are present to avoid the possibility of a fire.
• Be sure to ground coil high-tension wire to block. Failure to ground coil wire
may cause damage to ignition coil in addition to being a safety hazard.
• Stay clear of all moving parts.
1. Remove ignition coil high-tension wire from distributor cap tower and ground it to engine
block with jumper wire. While cranking engine with starter motor, lubricate starter motor
front bushing through oil cover with motor oil or its equivalent. Reinstall coil high-tension
wire.
2. Remove plastic plug from flywheel housing. Lubricate starter motor shaft with motor oil
through hole in flywheel housing. Reinstall plastic plug.
72019
a
a-Lubrication Point
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General