COLLECTORS SERVICE MANUAL NUMBER 23
Page 7D-4 90-861326--1 MARCH 1999
Component Replacement
To replace any components in exhaust system, the following must be adhered to:
• All mating surfaces must be clean.
• O-ring must remain in groove to properly seal joints to prevent leakage.
• Torque all bolts to 20-25 lb. ft. (27-34 N·m).
• Tighten all clamps securely.
72736
b
a
a-Mating Surface
b-O-Ring
72737
b
a
c
a
d
e
f
a
c
a-Clamps
b-Exhaust Pipe Elbow
c-Exhaust Hose
d-Water Shutters
e-Bolts and Lockwashers
f-Exhaust Pipe
Downloaded from https://needmanual.com/!
To Next Page
Loading...
