Section 4 - Setup and Calibrations
Page 60 90-8M0120668 eng MARCH 2016
Alarms
Alarms >
Alarm History
Shows legacy alarms
NOTE: See text following table.
Alarm Settings >
NOTE: These settings must be enabled to
receive alarms.
Shallow water—On—dot, Off—no dot
Deep water—On—dot, Off—no dot
Speed through water rationality fault—On—
dot, Off—no dot
Fuel remaining low—On—dot, Off—no dot
Fuel Tanks >
PORT FUEL low—On—dot, Off—no dot
PORT FUEL high—On—dot, Off—no dot
STBD FUEL low—On—dot, Off—no dot
STBD FUEL high—On—dot, Off—no dot
Oil tanks >
Oil low—On—dot, Off—no dot
Oil high—On—dot, Off—no dot
Fresh water tanks >
Fresh water low—On—dot, Off—no dot
Fresh water high—On—dot, Off—no dot
Gray water tanks >
Gray water low—On—dot, Off—no dot
Gray water high—On—dot, Off—no dot
Black water tanks >
Black water low—On—dot, Off—no dot
Black water high—On—dot, Off—no dot
Live well water tanks >
Live well low—On—dot, Off—no dot
Live well high—On—dot, Off—no dot
Show all Helm
alarms
On—dot, Off—no dot
When in Alarm History, press and hold the PAGES button. A pop‑up window will appear with the option to clear all faults.
Select it and the history will be cleared. Alarm history and data cannot be saved or transferred from the VesselView unit.
Alarm Settings allows the operator to select and change the parameters—minimums and maximums, as to when an alarm will
sound.
The Show all Helm alarms checkbox can be turned on—dot, or off—no dot.
Personality File
To Next Page
Loading...
Need help?
General
