Mercusys MP510 - 3.3 Wi-Fi Move

11
Chapter 3 Congure via Web Management Interface
3. Change the Network Name. You can also click Default to use the default
network name, e.g. HomePlugAV. However, if the default name is used, the Wi-Fi
Move function will be automatically disabled.
4. Click Save to make the settings eective.
3.3 Wi-Fi Move
Wi-Fi Move is enabled by default. With the feature enabled, any changes made to the
Wi-Fi settings and LED schedules of one powerline extender will be automatically
synchronized to other powerline extenders whose Wi-Fi Move feature is also
enabled on the same powerline network .
Follow the steps below to enable the Wi-Fi Move feature:
1. Connect to the powerline extender wirelessly. Visit http://mwlogin.net, and log in
with the password you set for the extender.
2. Go to Advanced > Wireless > Wi-Fi Move.
3. Toggle on Wi-Fi Move to enable the feature.
Note:
When Wi-Fi Move is enabled, the following features will be synced: Wireless SSID & Password, Wireless
Security, Wireless Mode, Wireless Radio Status, Wi-Fi Schedules, LED Schedules, Wi-Fi Clone Settings,
MAC Filter Settings, Parental Controls, and Guest Network.