Mercusys MP510 - 3.4 Wi-Fi Clone; 3.5 Wireless Network; 3.5.1 Customize Wireless Settings

12
Chapter 3 Congure via Web Management Interface
3.4 Wi-Fi Clone
If you want to copy wireless settings from the router to the extender and use the
same SSID and password to access the internet in the house, please follow steps as
below.
1. Before cloning, make sure your router supports the same band as your extender.
2. Plug your extender near your router.
3. Press the WPS button on your router
4. Within two minutes, press the Wi-Fi button on the bottom of the extender for 1
second. The LED starts blinking orange.
Done!
When the LED blinks orange quickly for 3 seconds and then stays solid green on,
the Wi-Fi Clone process is complete.
3.5 Wireless Network
3. 5. 1. Customize Wireless Settings
The powerline extender’s wireless network name (SSID), password, and security
option are preset in the factory. The preset SSID and password can be found on the
product label. You can customize the wireless settings according to your needs.
Connect to the powerline extender wirelessly. Visit http://mwlogin.net, and log in
with the password you set for the extender.
Go to Basic > Wireless Settings page.
To enable or disable the wireless function:
Select the box to enable the wireless function. Deselect the box to disable wireless
function. If disabled, all wireless settings will be ineective.
To change the wireless network name (SSID) or hide SSID:
The default SSID is MERCUSYS_XXXX, and the default password is printed on the
product label. You can change the default ones by directly entering new ones in the
eld. SSID is up to 32 characters, and the value in both SSID and password is case-
sensitive.