Name: Mercusys MW306R
Brand: Mercusys
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Chapter 4

• Network Destination - The destination IP address that you want to assign to a

static route. This IP address cannot be on the same subnet with the WAN IP or

LAN IP of Router A. In the example, the IP address of the company network is the

destination IP address, so here enter 172.30.30.1.

• Subnet Mask - The Subnet Mask determines which portion of an IP address is the

network portion, and which portion is the host portion.

• Default Gateway - The IP address of the gateway device to which the data packets

will be sent. This IP address must be on the same subnet with the router’s IP which

sends out data. In the example, the data packets will be sent to the LAN port of

Router B and then to the Server, so the default gateway should be 192.168.1.2.

• Interface - Determined by the port (WAN/LAN) that sends out data packets. In the

example, the data are sent to the gateway through the LAN port of Router A, so LAN

should be selected.

• Description - Enter a description for this static routing entry.

5. Click SAVE.

6. Check the Routing Table below. If you can find the entry you’ve set, the static routing is

set successfully.

4. 3. Wireless

4. 3. 1. Wireless Settings

1. Visit http://mwlogin.net, and log in with the password you set for the router.

2. Go to Advanced > Wireless > Wireless Settings.

3. Configure the wireless settings for the wireless network and click SAVE.

Questions and Answers:

Need help?

Do you have a question about the Mercusys MW306R and is the answer not in the manual?

Mercusys MW306R Specifications

General