1
3
2
This appliance has a polarized plug (one blade wider than the other). To reduce the risk of
electric shock, this plug is intended to fit in a polarized outlet only way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit contact a qualified electrician
to install the proper outlet. Do not modify the plug in any way.
9
Warning:
Insert the clean pocket under the looper cover.
Be sure the left side of clean pocket is mounted near the
cutter where the scraps drop.
* Be sure that the electrical voltage of the electric outlet (wall receptacle) is the same as the rated
voltage of the motor.
* Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything
on top of it when not in use.
* Disconnect the power line plug from the electric outlet when changing needles, presser feet
or when leaving the machine unattended. This eliminates the possibility of starting the machine
by accidentally pressing the controller.
Replacement
To remove, hold the clean pocket as shown and
pull it outward.
Removal
POLARIZED PLUG INFORMATION (FOR U.S.A. & CANADA ONLY)
7. REMOVAL AND REPLACEMENT OF
CLEAN POCKET
To Next Page
Loading...
Need help?
General
