To Thread The Machine Correctly
1) Threading the (Green)Upper Looper
16
Caution:
Be sure to turn off power switch.
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull
thread along the right
side of button as
illustrated.
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Thread the upper looper as indicated 1~9.
Pass thread from back to the front through the
thread guide 1.
Raise Presser foot to release tension discs.
2
4
3
3
3
2
2
4
7
6
9
8
2
5
3
1
1
To Next Page
Loading...
