b
d
b
c
a
47
The stationary knife should be changed when it
becomes dull.
The stationary knife can be replaced according to
the directions provided, however if there are any
difficulties experienced, consult your dealer
representative to make the replacement.
Be sure that the power line plug is disconnected
from the electric source.
Open the looper cover and set the moveable upper
knife (a) in the working position.
Loosen the stationary knife set screw (b) and remove
the stationary knife (a).
Turn the hand wheel to lower the stationary knife holder
to its lowest position.
In this position, put a new stationary knife in the
groove of the stationary knife holder, making sure
that the edge of the stationary knife is approximately
0.5 to 1.0 mm below the surface of the fixed cutting
blade (d).
Tighten stationary knife set screw (b).
Before replacing the stationary knife,
disconnect power line plug from the wall
receptacle.
0.5~1mm
How to Replace the Knifemoveable upper
Danger:
To Next Page
Loading...
