Anti-spill net
Spool cap
Thread spool
Press in
10
When using synthetic threads that easily spill off
the cone, slip the anti-spill net furnished with the
machine over the thread from the bottom of the
cone leaving the thread end hanging free at the
top the anti-spill net as shown at right.
Take out the thread guide from the top of
Styrofoam, and insert it as shown on the right
illustration.
This machine is shipped with the thread guide
holder on the top of styrofoam.
Fully extend the thread guide holder.
The two joints on the telescope will click into place
when they are correctly positioned.
Center the thread guides above the spool pins.
Place thread over the cone adapters on the spool
pins.
When using a regular thread spool, fit the spool cap
supplied with the machine onto the thread spool as
shown at right.
Setting Up the Thread Guide Holder
8. PREPARATION FOR THREADING
Anti-spill Net
Spool Cap
To Next Page
Loading...
Need help?
General
