R
N
R
37
This machine can sew four types of rolled hems.
Rolled hemming is done by rolling and overedging
the fabric edge.
Light weight fabrics such as lawn, voile, organdy,
crepe, etc. perform the best.
Rolled hemming is not suited for heavy or stiff
fabrics.
NOTE: Rolled hemming can only be performed
with the overedge right needle.
Remove the overedge left needle.
Move seam width finger knob to setting R.
Align left face of seam width finger support plate
with R mark on throat plate by turning seam width
adjustment knob, as required.
Set stitch length dial to "1~2" and a fine seam
will be sewn.
Needle: HAx1 (130/705H)
Thread: A variety of thread combinations can be
used for rolled hemming.
Caution:
Be sure to turn off power switch.
N
2
1
23. HOW TO SEW A ROLLED HEM
Machine Set up
To Next Page
Loading...
Need help?
General
