44
Cut out approximately 2cm (51/64 inch) from the corner,
in line with the overedge seam edge.
Sew one stitch beyond point (A) and stop.
Raise needle and presser foot.
Pull the fabric to the rear of the machine just enough
to release the thread caught on the finger of the throat
plate.
Note: Presser foot has been removed to show detail.
Turn the fabric and lower the presser foot so that the
knife is positioned in line with the cut edge.
Pull slack threads up, then start to sew.
Fold the fabric with the wrong sides together and sew.
Press the pin tucks in the same direction.
Cutting line
Cutting line
Cutting line
A
A
Knife
2cm
2cm
(1) Outside Corner
Turning Square Corners
To Next Page
Loading...
