40
Hold the thread chain when you begin sewing to
keep it from curling into the seam.
Apply a small drop of liquid seam sealant to the
end of the seam. Allow to dry, then cut the chain
close to the stitches.
Note: Test the liquid seam sealant for color
fastness before use.
Place a slight tension on the material in the sewing
direction and a finer seam finish can be obtained.
The minimum overedge stitch width that can be
obtained for rolled hemming is approximately
1.5 mm (1/16 inch) since the cutting width cannot
be set below 3.5 mm (9/64 inch).
To Secure the Rolled Hem Thread Chain
Additional Information About Rolled Hemming
To Next Page
Loading...
