merten KNX - 4 About this User Manual

30
4 About this user manual
Your system integrator has configured the 7" touchpanel with specialist
software (ETS) according to your requirements and provided you with
comprehensive instruction on the operation of the connected loads. The
chapters that follow provide additional tips on how to operate the 7" touch-
panel only.
The screenshots shown in this user manual are examples only and may dif-
fer from your individual implementation. The basic design remains the
same, however. The same applies to the designations provided in the in-
dividual chapters of the screen pages, buttons, keys or controls. The oper-
ating steps relate to the display shown, the controls being located in the
optimum screen for you but in the same place and possibly with a different
caption.
This manual will show you how to:
- make it seem that someone is at home even when you are away
(⇒ chapter 7.2);
- acknowledge and view alarms (⇒ chapter 7.3);
- import and save images for a slideshow (⇒ chapter 8.1);
- adjust the brightness of the screen (⇒ chapter 8.2);
- calibrate your touchpanel (⇒ chapter 8.3);
- surf the Internet (⇒ chapter 7.4);
- enter a password (⇒ chapter 6.3);
- prepare the touchpanel for cleaning (⇒ chapter 9);
- record switching habits (⇒ chapter 7.2);
-change to standby mode (⇒ chapter 8);
- define the standby screen (⇒ chapter 8.2);
- save and delete scenes (⇒ chapter 6.2);
- activate and deactivate the button tone and change its loudness
(⇒ chapter 8.4);
-operate loads (⇒ chapter 6.1);
- define timing instructions (⇒ chapter 7.1).
Visit us on the Web
Further information on our products is available at
www.merten.com.
Should you have any questions or require changes to the set-up or
configuration of your touchpanel please contact your system inte-
grator.