43
8 System settings
The system settings are accessed via the [SYSTEM] button. The following
functions are available to you (spread over two screens):
Screen 1/2
• Installation
This function is required by your system integrator during installation
and is not enabled for your use.
• Data exchange (⇒ chapter 8.1)
Loading of your own images for the slideshow in standby.
• Cleaning
Deactivates the touchpanel for 30 seconds, to allow you to clean the
screen surface (see also recommendations under in chapter 9).
• Standby
Switches the touchpanel to standby mode.
•Display (⇒ chapter 8.2)
Sets the strength of the background lighting on the screen and the
type of standby mode.
• Touch adjustment (⇒ chapter 8.3)
Calibrates the touchpanel, if you sense that you are occasionally off
the mark with your touch.
• Signalling (⇒ chapter 8.4)
Sets the loudness of the touch tone and the alarm notification.
•Time / Date (⇒ chapter 8.5)
Manual setting of time, date and time zone.
Screen 2/2
•Service
We are there for you. If you have any queries, please contact custom-
er support (address and telephone number provided).
• Run script
This function is required by your system integrator for maintenance
purposes and is not enabled for your use.
•System status
Shows you the versions of the individual program files. These may be
needed in the event of a problem when you talk to your system inte-
grator or to customer support.
To Next Page
Loading...