39
4. Define the switching value for the load. Depending on the switching
channel you can
-Switch loads:
in the listbox tap and select 'ON/DOWN' or 'OFF/UP'
- Define scenes:
tap the input field and using the number pad enter the scene
number (8-bit scenes philosophy only possible ā chapter 6.2.1)
- Switch the operating mode of the thermostats controlled:
tap the listbox and choose from 'Absent', 'Present', 'Night mode',
'Frost/Heat protection' and 'Off'.
5. Select the days of the week on which the switching programme is
to be run, e.g.: weekends only ('Saturday' and 'Sunday' marked).
6. Tap [Save] to keep these settings.
Tips on thermostats
Regulation of the room temperature is by means of locally installed room
thermostats. Likewise these will have been pre-programmed by your sys-
tem integrator and can be operated in the following modes:
'Present' The room is being used. The room temperature corre-
sponds to the SETPOINT temperature.
'Absent' The room is not being used. The room temperature is
lowered by a specified margin.
'Night operation' During the night. The room temperature is lowered by
a specified margin.
'Frost-/
Heat protection'
If the temperature goes below (frost protection) or
above (heat protection) a certain value, the heating or
the cooling, respectively, is switched on.
'Off' The thermostat is "switched off". If the temperature
drops below the set dew point (at below dew point the
air deposits moisture), the heating is switched on.
To Next Page
Loading...