Metallisation MK 73 - Maintenance and Repair Procedures

Page 27 of 64
SECTION 4
MAINTENANCE & REPAIR
4.1 Recommended Spares
4.2 Routine Maintenance
4.3 Disconnecting the Pistol
4.4 The Nozzle Assembly
4.4.1 Removal & Dismantling
4.3.2 Nozzle Re-Assembly
4.5 The Gas Head & Main Valve
4.5.1 Removal & Dismantling
4.5.2 Gas Head & Valve Re-Assembly
4.6 The Drive Box
4.6.1 Dismantling the Wire Drive Assembly
4.6.2 Dismantling the Air Shield Valve
4.6.3 Dismantling the Speed Control
4.6.4 Re-Assembling the Speed Control
4.6.5 Re-Assembling the Air Shield Valve
4.6.6 Re-Assembling the Wire Feed Drive
4.7 The Drive Motor
4.7.1 Dismantling the Drive Motor
4.7.2 Re-Assembling the Drive Motor
4.8 Feed Roller Tension
4.8.1 Checking Feed Roller Tension
4.8.2 Adjusting Feed Roller Tension