MetalMaster PB-830T - User Manual

Questions and Answers

P
preedAug 9, 2025
What to do if MetalMaster PB-830T Industrial Equipment has no clamping?
- J
  Jason FoxAug 9, 2025
  If your MetalMaster Industrial Equipment is not clamping, several issues could be the cause. First, a pressure relief valve or directional valve may be blocked; try cleaning the valve. A failure in either of these valves could also be the problem, requiring you to change the valve. Another possibility is a blocked suction filter, which you should clean. Check the pump for failure and replace it if necessary. Look for any leakage in the pipes or cylinder and repair. Finally, try pressing the reset button.
M
michelle38Aug 15, 2025
Why does the apron not operate on my MetalMaster PB-830T Industrial Equipment?
- J
  Jillian WallaceAug 15, 2025
  If the apron on your MetalMaster Industrial Equipment isn't operating, it could be due to low pressure or leakage in the lifting cylinders. Check the system pressure. If there's a leak, replace the piston seal. Also, pressing the reset button might solve the problem.
N
nealdouglasAug 21, 2025
How to fix uneven material bend on MetalMaster Industrial Equipment?
- F
  fproctorAug 21, 2025
  If the material bend is uneven on your MetalMaster Industrial Equipment, it could be due to several reasons. The clamp setting might be wrong for the material thickness, so you should re-adjust the cam settings. Also, the finger edges might be uneven, in which case you should adjust the pan clearance and the fingers.
V
victoriastewartAug 27, 2025
What to do if oil is leaking from the cylinder of MetalMaster PB-830T?
- A
  Amanda MorrisAug 27, 2025
  If oil is leaking from the cylinder of your MetalMaster Industrial Equipment, it's likely that the gland seal is damaged. You will need to change the seal.
M
Matthew WhiteSep 2, 2025
How to stop oil from leaking from fittings on MetalMaster PB-830T Industrial Equipment?
- B
  Brenda WilliamsSep 2, 2025
  If you notice oil leaking from the fittings on your MetalMaster Industrial Equipment, the fittings are likely loose. Tighten the fittings to resolve this issue.