Metrix MTX 3292 - Switch

Description of the instruments
12 100,000 cts digital multimeters
Description of the instruments (continued)
Switch
Changing from one setting to another resets the measurement mode. Around
the switch, a fixed orange LED indicates which function is selected and an
orange LED flashes for setup. During the charging cycle (OFF), each function
LED lights by turns to indicate charging in progress.
In the centre, a "4 position" navigator is used for:
1. navigating up and down, to:
- select a menu or a function,
- manually select the range or graphic scale under " ",
- increment or decrement the selected variable.
2. navigating right and left, to:
- move from one selected variable to another.
Keys of the switch
Short press
Successive short presses
Current measurement in
AC RMS
Temperature measurement T
and selection of the unit
Selection of the types of sensor:
- Pt 100 or Pt 1000
- TCJ or TCK
Capacitance measurement
Current measurement by clamp,
selection of AC, DC, or AC+DC
coupling
Configuration of the "Clamp" menu:
type of measurement, ratio, and unit
Resistance measurement,
audible continuity
measurement, 100 Ohm
range, diode test
Selection of the continuity, 100Ohm
or diodes functions
Frequency measurement
AC voltage measurement (AC
RMS) and selection of
coupling
VlowZ
SETUP, on 3 levels
Setup 1/3, Setup 2/3, Setup 3/3
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187