Three operating modes can be accessed
by the key:
- the AUTO mode [F1]
- the AUTO Pk mode [F2]
- the MANUEL mode [F3]
When a measurement is being acquired,
the AUTO mode is active as default and
range selection is managed
automatically by the multimeter.
In the AUTO PEAK mode, changes of
range occur only when the acquisition of
a higher peak makes a higher range
necessary.
The AUTO PEAK mode is available only
on AC and AC+DC measurements in V
and A. It avoids the untimely overshoot
of the peak factor specified for the
instrument.
When the MANUAL mode is selected
and it is valid for the function concerned,
the keys of the navigator allow a
change of the measurement range.
Measurements concerned: voltage, current
(in series or clamp), resistance,
capacitance
To Next Page
Loading...
