General directions
6 100,000 cts digital multimeters
General directions (continued)
Disconnect everything connected to the instrument and press the key to
switch it off.
Use a soft cloth, moistened with soapy water.
Rinse with a damp cloth and dry rapidly with a dry cloth or forced air.
Make sure that no foreign objects interfere with the operation of the device
by which the leads are snapped into place.
4 primary batteries (R6, AA format)
or 4 storage batteries (Ni-MH type, LSD, AA format).
Charging the
storage batteries
You can charge the storage
batteries without removing
them. Use the external
charger supplied with the
multimeter.
During the charging, the
multimeter remains
operational.
However, some of its metrological characteristics may be altered.
During the charging cycle, each function LED lights by turns to indicate that
charging is in progress.
On the screen, the user sees the charge level of the storage batteries.
Charging stops automatically when they are fully charged (approximately 6h for
2400mAh).
For more details, refer to the "Before recharging the storage batteries" section
in the Appendix.
Replacement
(primary or storage
batteries)
During this replacement, the internal clock is preserved for approximately 45s.
Before replacing the fuse (reached by opening
the bottom compartment), disconnect the
instrument from any source of current. During the
replacement, make sure that only a fuse of the
appropriate rating and specified type is used.
Using another type of fuse and shorting the fuse
holder are strictly forbidden.
Fuse: for example, SIBA/5019906
11A: 10x38 -1,000V -F
Breaking capacity: >18kA
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187
To Next Page
Loading...
