General directions
100,000 cts digital multimeters 3
General directions
Congratulations! You have just become the owner of a portable colour
graphic multimeter.
We thank you for this sign of confidence in the quality of our products.
The line of instruments to which it belongs comprises the following models:
4 R6 primary batteries or 4 storage batteries (provided)
IR/USB (Bluetooth, optional)
It complies with safety standard NF EN 61010-1 + NF EN 61010-2-030
concerning electronic measuring instruments.
For best results, read this manual closely and observe the precautions of use.
Failure to observe these warnings and/or directions may damage the
instrument and/or its components and may endanger the user.
Precautions and
safety measures
This instrument is been designed to be used as follows:
- indoors
- in an environment of pollution degree 2
- at an altitude of less than 2000m
- at a temperature between 0°C and 40°C
- at a relative humidity below 80% up to 35°C.
The safety of any system incorporating the instrument is the responsibility
of the system integrator.
It can be used for measurements on 1000V circuits in CAT III and
600V circuits in CAT IV.
However, some accessories may lead to the use of this instrument on circuits
of a lower voltage and category.
Comply with the environmental and storage conditions.
Check the integrity of the guards and insulation of the accessories. Any item
of which the insulation is deteriorated (even partially) must be removed from
service and scrapped. A change of colour of the insulation is a sign of
deterioration.
Supply: primary battery or Ni-MH battery and specific charger supplied with
the instrument. It must be connected to line power :
(230V ±10%, 300V - CAT II), (US version: 110V ±10%).
Read closely all notes preceded by the symbol.
As a safety measure, use only the appropriate leads and accessories
supplied with the instrument or approved by the manufacturer.
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187
To Next Page
Loading...
