Metrix MTX 3292 - SX-DMM Software

SX-DMM software
44 100,000 cts digital multimeters
SX-DMM Software
SX-DMM: Processing
software
These multimeters can be interfaced directly with a PC or other computer using
"SX-DMM" acquisition software:
In the "General adjustments" menu of the multimeter:
 Select infrared communication (IR is default) by the Comm. function or BT if BT
version multimeter
 Select the Modbus communication protocol
 Parameterize the infrared transmission rate by the IR baud function:
9600/19200/38400 Baud.
 The default transmission rate is 38400 Baud.
The other transmission parameters are fixed (8 data bits, 1 stop bit, no parity).
Connection of the
isolated USB optical
lead supplied
1. Connect the isolated optical lead to the isolated optical input of the
multimeter (on the side of the multimeter). Mechanical polarization prevents
connection in reverse.
Connect the USB lead to one of the USB ports of the PC.
2. Install the USB driver on your PC (see the data sheet on the CD provided).
Installing
the "SX-DMM"
software
1. Install the "SX-DMM" software on the PC using the CD.
2. Start the software for data acquisition and study the various display
possibilities (curves, tables, etc.).
 The symbol appears on the display unit when the instrument is
controlled from the PC (REMOTE mode).
For more information, refer to the "Help" menu of the software.
Isolated optical connector
USB
Interface cable
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187