Functional description
100,000 cts digital multimeters 27
2. Description of the “Keypad” keys (continued)
Validating Freq. by the [F3] key opens a menu
for adjustment of the recording interval in
hours, minutes, seconds
Modification of the value using the keys
of the navigator
Validation of the interval of recording of the
measurements and exit from the successive
menus by the Ok key [F1].
The maximum recording interval is 23h,
59min, 59s. Default recording interval 1s.
Recall of a recording
campaign
on the multimeter
(or on the PC using
SX-DMM software,
see the §. SX-DMM
Software)
A zoom is available, if the
recorded value >MEM 220.
The curve displayed is
adapted to the graphic
window according to its min.
and max. values and the
number of records.
Selection of the Main function, by default,
and display with Cursor selected.
Zoom and Trace on MTX 3293 version only.
Displacement of the cursor by the navigator
- moves the zoomed part (icon present,
if a zoom is active)
- activates, deactivates a zoom
(icon present, if a zoom is possible)
Zoom of the trace by selection of the zone
in red border in the upper part of the record
But access to the secondary
measurements to be displayed by pressing
TRACE, then selection by keys [F2] to [F4],
Selection of the function to be displayed
Example:
- main function: V
- secondary function: FREQ, dB, MATH
If recording has been started, MEM is
incremented and changes of function are not
available (attempts produce a low-pitched
beep), except for the SETUP menu, which can
still be looked up. The acquisition in progress
must be aborted (press MEM) to change a
parameter, a function, or a configuration.
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187
To Next Page
Loading...
