Functional description
26 100,000 cts digital multimeters
2. Description of the “Keypad” keys (continued)
Look-up of the recorded files under [F1]
Files and selection by the navigator,
then possibility:
- of opening [F1],
- of deleting a selected sequence [F2],
- of deleting all recorded sequences [F3]
Select the Files menu in the MEM
function to display the list of successive
records.
Each record is identified by its date and its
start time.
The selection of a record is
accompanied:
- by the number of values
recorded,
- by the recording interval
- by the function in which they
were made,
- by the secondary functions
present during the recording, if
any.
The number of recording
sequences is limited to 10.
Programming the number of records
Defining a number of records for a
measurement campaign makes it
possible to stop recording automatically.
Selection of the max number of records
using the navigator (6500 or 1000
measurements max.); default [F2] is
1000 records
If MEAS+, SURV, or REL secondary
measurements are programmed, it will
be necessary to make allowance for
them in the depth of recording selected.
- Programming the recording frequency
- Selection of the digit to be modified by
the navigator key.
- Modification of the value by the keys:
- Validation of the number of records by
Ok [F1]
- Exit from the successive menus by the
Cancel key [F4].
The recording capacity is limited to 6500
measurements (1000 for the MTX 3292).
To Next Page
Loading...
