How are the various quantities measured?
30 100,000 cts digital multimeters
How are the various quantities measured? (continued)
The 100mV range is present only
in MANUAL mode, by .
In all cases, "OL" is displayed above 1050V
and a beep sounds when the measurement
exceeds 600V.
The hazardous voltage symbol is displayed
if "V" exceeds 60 VDC or 25 VAC
1. Press on the V function, then select the
coupling according to your measurements:
AC, DC, AC+DC, LowZ (AC is default).
2. Connect the black lead to the COM terminal
and the red lead to V.
3. Read the measurement indicated on the
display unit; the graph of trend values >88s
is displayed on the screen or selection of
secondary measurement Meas…/MEAS+
(4 display units max).
4. It is possible to activate an MLI filter
(SETUP/Measurement/filter/yes) for
measurements on a variator: the cutoff
frequency of the filter <300Hz.
5. It is possible to display the specifications of
the range for metrology or a RELative
measurement.
6. Surveillance of voltage by activation by
Meas…/SURV
7. Recording of data internal to the multimeter:
- Mem to start the campaign
- Mem to stop the campaign
- then look-up of the data by long press on
Mem…
- Processing of the measurements: plot of
the main measurement and display of the
secondary measurements.
To Next Page
Loading...
