Metrix MTX 3292 - Page 50

Technical characteristics
50 100,000 cts digital multimeters
Technical characteristics of the MTX 3292, MTX 3293 (continued)
Currents
Three possible modes: DC, AC, AC+DC
In DC mode, you can measure a direct current or the DC component of an alternating
current.
In the AC and AC+DC modes, you can measure the true RMS (TRMS) value of an
alternating current with/without its direct component (no capacitive coupling in "DC"
mode).
Fuse: ex.: SIBA/5019906/11A (10x38-11000-DMI-30kA-CR 1000V, very rapid action).
DC
Range
Input impedance
Resolution
Protection
Accuracy
1,000µA
170
10nA
11A
20A < 30s
0.1% L + 15 D
10mA
17
0.1µA
0.08% L + 8 D
100mA
1,7
1µA
1,000mA
0.17
10µA
0.15% L + 8 D
10A
0.03 ()
100µA
0.5% L + 15 D
100A ()
1,000µA
() with the fuse supplied with the device
() 100A range limited to 20A
Specifications valid from 0% to 100% of the range
Limiting condition on the current
An overload of 20A is acceptable for 30 seconds max. with a pause of at least
5 minutes between measurements.
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187