Metrohm 916 Ti-Touch Manual - Short Instructions

5.7 Connecting sensors
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24
￭￭￭￭￭￭￭￭
916 Ti‑Touch
5.7.2 Connecting a pH, metal or ion-selective electrode
Connect the pH, metal or ion-selective electrode as follows:
1
Plug the electrode plug into the Ind. socket of the Ti‑Touch.
Figure 7 Connecting a pH, metal or ion-selective electrode
NOTICE
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to pull
out the plug again, you first need to pull back the outer plug
sleeve.
5.7.3 Connecting a reference electrode
Connect the reference electrode as follows:
1
Plug the electrode plug into the Ref. socket of the Ti‑Touch.

Metrohm 916 Ti-Touch Specifications

General

Brand	Metrohm
Model	916 Ti-Touch
Category	Laboratory Equipment
Language	English