￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Installation
916 Ti‑Touch
￭￭￭￭￭￭￭￭
27
NOTICE
The red plug must always be plugged into the red socket for the
purpose of shielding against disruptions.
If you use an electrode with an integrated NTC sensor, then you
must plug the red plug into the red socket.
5.7.6 Connecting the iConnect
The external measuring interface 854 iConnect can be connected to the
iConnect connector.
Connecting the 6.2168.000 mini USB adapter cable to an
instrument
If the mini USB adapter cable is not connected to the instrument yet, pro-
ceed as follows:
1
Plug the mini USB adapter cable (2) into the iConnect connector of
the instrument (1). Observe the correct orientation (markings).
Figure 11 Plugging in the mini USB adapter cable
Depending on the instrument's model version, there may be several
iConnect connectors.
2
Leave the adapter cable plugged in to protect the connector inside
the instrument (1) against mechanical impact.
Connecting the 854 iConnect to the adapter cable
Make sure that the mini USB adapter cable is connected to the instru-
ment.
To Next Page
Loading...
Need help?
General
