￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Operation
916 Ti‑Touch
￭￭￭￭￭￭￭￭
33
NOTICE
If a buret unit is connected, then a request appears to carry out
the Prepare function:
All tubings and the cylinder are rinsed with the Prepare function.
The preparing of the buret unit is described in the chapter Manual
control of the detailed manual.
￭ Confirm the message with [OK].
The main dialog is displayed:
Switching off the instrument
CAUTION
The 916 Ti‑Touch must be switched off by pressing the power switch
on the rear of the instrument before the electricity supply is interrupted.
If this is not done, then there is a danger of data loss.
To Next Page
Loading...
Need help?
General
