Metrohm 916 Ti-Touch Manual - Short Instructions

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 Introduction
916 Ti‑Touch
￭￭￭￭￭￭￭￭
3
￭ MET
Monotonic equivalence point titration. The reagent is added in con-
stant volume steps.
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
￭ SET
Endpoint titration at one or two specified endpoints.
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
￭ STAT
Titration with constant maintenance of the measured value.
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
￭ MAT
Manual titration with manual dosing and manual ending.
Measuring modes (optional):
– pH (pH measurement)
– U (potentiometric voltage measurement)
￭ MEAS
Measuring modes:
– pH (pH measurement)
– U (potentiometric voltage measurement)
– Ipol (voltametric measurement with selectable polarization cur-
rent)
– Upol (amperometric measurement with selectable polarization
voltage)
– T (temperature measurement)
￭ CAL
pH electrode calibration.
Measuring mode:
– pH (calibration of pH electrodes)
– ELT (Electrode test for pH electrodes)

Metrohm 916 Ti-Touch Specifications

General

Brand	Metrohm
Model	916 Ti-Touch
Category	Laboratory Equipment
Language	English