Metrohm Combustion-IC-System - Page 33

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Start-up
Combustion-IC-System
￭￭￭￭￭￭￭￭
27
NOTICE
It can sometimes happen that an instrument is not automatically
recognized when it is newly connected to an existing system.
When an instrument is not automatically recognized, then the
"basic initialization" has to be run in MagIC Net. Additional infor-
mation concerning the basic initialization can be found in the
MagIC Net online help or in the MagIC Net manual.
3
Loading the method
Workplace ▶ Run
￭ Select the Equilibration tab.
￭ In the Method field, load the Preparation of Combustion IC
method.
4
Starting the equilibration
￭ Start the equilibration with [Start HW].
The instrument is ready to measure as soon as equilibration has fin-
ished.
Putting the Combustion IC system (TEI) into operation
1
Starting the software
￭ Switch on the computer and start the MagIC Net software and
TEIS.
￭ Enter the user name and the password in each software.
MagIC Net: The software starts and shows the Workplace program
part.
TEIS: The software starts and shows the Task Manager program
part.
2
Switching on the instruments
￭ Switch on the Combustion Oven (TEI) and the Liquid Autosampler
CIC (TEI), Solid Autosampler CIC (TEI) or the GLS Sampler CIC (TEI),
if present.
￭ Switch on the ion chromatograph and the 920 Absorber Module.
MagIC Net detects both instruments and asks if they are to be
saved to the device table.
￭ Confirm all of the prompts with [Yes].