SediGraph III 5120 Service Calibration Procedure
Mar 2010 8-1
8. CALIBRATION PROCEDURE
This chapter contains the calibration and test procedure used in Micromeritics’ Final Assem-
bly Department. It is provided as a reference so that you will be familiar with the calibration
procedures and instrument tests that are performed on the instrument during manufacture.
The methods used at the factory may differ from the methods documented in Chapter 7, Main-
tenance Documents. Use the established service calibration and test procedure unless
otherwise directed by a Micromeritics Service Managers or Service Specialist.
• Product Calibration Procedure
, P/N: 512-34000-76.
To Next Page
Loading...
