CE-500 MDT Hardware Guide
The platform’s system manages automatic power management and battery recharging control to
provide a most effective battery service. However, the developers of portable applications need to:
Consider the power limitations of this mode
Provide accurate management of significant power consumer features, such as: wireless
communication interfaces, voice enabled solutions, and so on
The operation time of the device while powered by the internal battery is directly dependent on the
device configuration and application performance. Nevertheless, the estimated time of continued
operation for standard applications is ~2 hours.
NOTE:
The operating temperature range of the CE-50X device including the battery option is
limited to 14 °F to 140 °F (-10°C to +60°C). The system automatically recognizes out-of-
range situations and stops the operation to prevent battery degradation.
Micronet delivers the battery pack charged for 40% of capacity. In this case, the shelf lifetime of the
pack is about six months. If you did not use the battery during this period, you must recharge the
battery up to 40% of capacity again to continue the storage. CE-50X devices provide a software utility
that charge the battery pack up to 40%. For more details on this utility, refer to the Internal Battery
section of the Developers Guide.
Before you begin to use the battery, you must to fully charge the battery pack by connecting a power
source to the device until the End Of Charge indication.
D
D
e
e
v
v
i
i
c
c
e
e
P
P
o
o
w
w
e
e
r
r
C
C
o
o
n
n
s
s
u
u
m
m
p
p
t
t
i
i
o
o
n
n
Table 8 – Device Current Consumption Parameter Table
CE-504 Model -
Current Consumption
CE-507 Model -
Current Consumption
Idle (no application activity)
Active (with full backlight and wireless communication)
To Next Page
Loading...