MICROPOINT qLabs ElectroMeter Q-1 - Getting a Fingerstick Sample

ADD BLOOD
120S
When qLabs
®
ElectroMeter is ready for
sample testing, it will beep and prompt the
user to apply a blood sample.
9.6 Getting a Fingerstick Sample
Good ngerstick technique is benecial to both the professional user and
the patient. Getting a good ngerstick will ensure minimal discomfort for
the patient and accurate test results for the user. Please sanitize the site of
the ngerstick with alcohol wipe before testing.
9.6.1 Maximize Good Blood Circulation
1) If needed, briey warm the hand in warm water or with a
heating pad.
2) Massage the nger with a downward motion several times
before performing the ngerstick.
3) Lower the hand to below the heart level when collecting the
blood drop.
9.6.2 Identify a site on the nger to puncture
1) On one of the middle ngers of either
hand.
2) Near the top of the nger on either side.
3) Away from any calluses or scars.
9.6.3 Clean the selected area with 70%
isopropyl alcohol, or an alcohol pad.
Dry thoroughly with cotton or gauze.
18
EN