To Next Page

To Previous Page

24 Port Gigabit Ethernet PoE Switch – User Manual Page 28 of 72

________________________________________________________________________

Parameter description

VID:

VLAN identifier. Each tag-based VLAN group has a unique VID. It appears only in

tag-based mode.

Member:

In modify function this is used to enable or disable if a port is a member of the

new added VLAN, “Enabled” means it is a member of the VLAN. Just tick the

check box () beside the port x to enable it.

Port:

Port number

Ingress Filtering Enabled:

Discard other VLAN group packets, only forward this port joined VLAN group

packets.

VLAN aware Enabled:

Discard other VLAN group packets, only forward this port joined VLAN group

packets.

Packet Type:

All:

Forward all tagged and untagged packets.

Tagged Only:

Forward tagged packets only and discard untagged packets.

PVID:

This PVID range will be 1-4094. Before you set a number x as PVID, you have to

create a Tag-based VLAN with VID x. For example, if port x receives an untagged

packet, the switch will apply the PVID (assume as VID y) of port x to tag this

packet, the packet then will be forwarded as the tagged packet with VID

Role:

This is an egress rule of the port. Here you can choose Access, Trunk or Hybrid.

Trunk means the outgoing packets must carry VLAN tag header. Access means

the outgoing packets carry no VLAN tag header. If packets have double VLAN

tags, one will be dropped and the other will still be left. As to Hybrid, it is similar

to Trunk, and both of them will tag-out. When the port is set to Hybrid, its pack-

ets will be untagged out if the VID of the outgoing packets with tag is the same

as the one in the field of Untagged VID of this port.

Untagged VID:

Valid range is 1~4094. It works only when role is set to Hybrid.

Microsens MS400863M User Manual

Other manuals for Microsens MS400863M