Microstep Website http://www.microstep.cc/eng
北京欣斯达特数字科技有限公司 Beijing Flourishing Start Digital Technology Co., Ltd
Contents
Safety notice…………………………………………………………………………………...1
Safety operation.……………………………………………………………………..……...1
Mechanical dangerousness…………………………………………………...…….1
High-voltage dangerousness….………………………………………………..….1
Power isolation…………………………………………………………………………....1
Working environment………………………………………………………………….1
Controller connection……………………………………………………………...….1
Good ground-connection……………………………………………………………2
Controller protection…………………………………………………………………...2
Others………………………………………………………………………….........……….2
Controller operation and maintenance…………………………………………....2
Controller operation………………………………………………………………….…2
Controller maintenance…………………………………………………………….....2
Declaration……………………………………………………………………………..……....2
Controller guarantee instruction……………………………………………….…2
Chapter 1 Controller functions overview and main menu………………..3
1. Controller functions……………………………………..……………………...…..3
2. Controller features…………………..…………………………………………........3
3. Hardware technical parameters……………………..………………………...3
4. Controller main menu……………….………………………………………….….3
5. Main menu instruction……………………………………………………..……...4
Chapter 2 Auto function…………………………….................................................4
Options instruction of Auto interface…………………………….....................4
2.1 enter process interface of Auto ……………………………......................4
2.2 enter Man (manual) interface……………………………………….….........6
2.3 enter Sectio (section) interface…….……………………….…...................8
2.4 enter BreakP (breakpoint) interface….................................................9
2.5 enter Figure interface……........................................................................9
2.6 enter Upload interface……....................................................................10
2.7 enter Assist interface…….......................................................................10
2.8 enter BackRe (backreference) interface……....................................11
Chapter 3 special instruction during automatic cutting……..................11
Chapter 4 Edit function……...............................................................................13
Options instruction of Edit interface……...................................................13
Chapter 5 Param (parameter) function…….................................................14
Options instruction of Param (parameter) interface……......................14
5.1 enter System interface……....................................................................14
5.2 enter Speed interface……......................................................................15
5.3 enter Ctrl (control) interface................................................................16
To Next Page
Loading...
