MicroStep CC-S1 User Manual

Microstep Website http://www.microstep.cc/eng
北京欣斯达特数字科技有限公司 Beijing Flourishing Start Digital Technology Co., Ltd
page: 4
5. Main menu instruction
Controller version number: current version information
[F2] Auto: automatic cutting program control
[F3] Man: manually adjust torch
[F4] Edit: edit/revise/USB input/output cutting program
[F5] Param (parameter): controller parameters set
[F6] Diagn (Diagnosis): check machine input/output state
[F7] Figur (figure): figures library
[F8] Help: help information of every function
Chapter 2 Auto function
Options instruction of Auto function
[F1] Exit: exit Auto operation
[F2] Man (manual): change to manual operation
[F3] Sectio (section): change to section operation
[F4] BreakP (breakpoint): breakpoint operation
[F5] Figure: figure operation
[F6] Upload: upload program
[F7] Assist: assist operation
[F8] BackRe (back to reference): enter operation of back to reference
2.1 Enter Auto interface
2.1.1 [0] SpeedSet: directly adjust speed parameters of cutting the current program
(IdleSped (speed of idle running (no load), CutSpeed (running speed), ManSpeed (speed of
manual operation), BackSped (speed of backward operation)).
Note:
If current speed settings is not bigger than max. speed (idlespeed) of the parameter
interface, speed settings of parameter interface will not be changed. If bigger than speed
settings of parameter interface and less than max. speed, speed settings of parameter
interface will be change. If bigger than speed settings of parameter interface, then run
based on max. speed.

MicroStep CC-S1 Specifications

General

Brand	MicroStep
Model	CC-S1
Category	Controller
Language	English