Name: Microtek ArtixScan DI 2125c
Brand: Microtek
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ArtixScan DI 2125c User's Manual 3

FCC Compliance Statement

This equipment (Model: MRS-600ADF) has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These

limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note: A shielded Hi-Speed USB interface cable with ferrite core installed on the

scanner connector end must be used with this equipment.

Caution: Changes or modifications not expressly approved by the manufacturer

responsible for compliance could void the user's authority to operate the

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Questions and Answers:

Need help?

Do you have a question about the Microtek ArtixScan DI 2125c and is the answer not in the manual?

Microtek ArtixScan DI 2125c Specifications

Scanning Specifications

optical resolution	600 x 600 dpi
scanning speed (simplex, line art)	20 ppm at 200 dpi
scanning speed (simplex, grayscale)	20 ppm at 200 dpi
scanning speed (simplex, color)	15 ppm at 200 dpi
scanning speed (duplex, line art)	40 ipm at 200 dpi
scanning speed (duplex, grayscale)	40 ipm at 200 dpi
scanning speed (duplex, color)	30 ipm at 200 dpi
scanning area	8.5" x 65" (216 mm x 1651 mm)

Paper Handling

feeder capacity	up to 20 sheets of 20 lb. paper or 1 piece of card
paper weight	10.7 to 32 lbs. (40-120 g/m²)
paper size minimum	3.15" x 2.1" (80 mm x 52 mm)
paper size maximum	8.5" x 65" (216 mm x 1651 mm)
card thickness	up to 0.078" (2 mm)

Roller Life