32 PRO X
Input Equalisation (E Zone)
Use EQ to equalise the input signal via the treble, hi-mid, lo-mid and bass lters,
which are situated in the input channel strip’s E zone. Treble and bass each have
a parametric lter option and three speci c shelving modes. Visual feedback for
EQ is via GUI only.
>> To EQ the input signal
1. In an input fast strip, press the quick access button of the desired EQ lter
(treble, hi-mid, lo-mid or bass). This will select the channel and open the
EQ lter’s processing area in the GUI’s channel strip. Alternatively, you can
navigate to it using the bass and treble up and down arrow buttons in the
E-zone (shown above).
2. In the input fast strip, press EQ to switch the EQ in. The EQ button’s LED will
illuminate when its EQ is switched in.
3. In the E zone, adjust the freq, width and gain control knobs to apply
EQ as desired.
4. Audition the di erent lters, including the ‘minimum harmonic disruption’
types, by scrolling through them using the SHAPE button.
NOTE: The minimum harmonic disruption lters are bright and deep,
which are available for treble and bass, respectively. These lters use
psychoacoustic phenomena to generate steep slopes that sound natural.
Graph shows the eects of EQ
LEDs for EQ
lter selection
indication
Filter quick
access button
Input fast strip
GUI channel strip
E zone
To Next Page
Loading...
Need help?
General
