Cleaning and care
79
Wipe lock
You can lock the display when cleaning the
control panel and the display to prevent
accidental operation during cleaning.
Target temperature:
66°C
Actual temperature:
51°C
Information
AutoOpen
Open the status window by tapping and
dragging the orange bar at the top of the
display.
Tap the symbol.
The display is locked to prevent operation.
Tap and hold the symbol for 5seconds
to end the wipe lock.
Cleaning the control panel
Only clean the control panel with warm
water and liquid dish soap, applied with a
soft sponge or cloth. Then dry the control
panel with a soft cloth.
Damage to the user interface.
Abrasive cleaning agents can damage the
user interface.
Do not use abrasive detergents!
Cleaning the machine front
To clean the stainless steel front, use a
damp cloth with a solution of liquid dish
soap and hot water, or with a non-abrasive
cleaning agent for use on stainless steel.
To help prevent re-soiling (fingerprints, etc.),
a suitable stainless steel care product can
be used after cleaning.
Damage to the surfaces.
Cleaning agents containing ammonia and
thinners can damage surfaces.
Avoid these products when cleaning.
Damage to the dishwasher caused by
ingress of water.
Do not clean the dishwasher or its imme-
diate vicinity with a hose or a pressure
washer.
Make sure that water does not enter the
dishwasher when it is being cleaned.
To Next Page
Loading...
