Troubleshooting
89
Problem Possible cause and solution
Peak-load negotiation: Heat-
ing mode temporarily dis-
abled.
This is not a fault.
Your energy management system has detected a peak
load in the power supply. Some components in the dish-
washer stop operating for the duration of the peak-load
negotiation.
Cycles until empty
This is not a fault.
The level of process chemicals has reached the value
specified for the remaining wash cycles and this is indi-
cated on the display.
Temperature compensation
after door opened: Program
will continue in min
This is not a fault.
If the door is opened during a program sequence and the
temperature in the wash cabinet is above 140°F (60°C),
pressure equalization takes place once the door is closed.
To Next Page
Loading...
