Miele PG 8504 - Cancel with Fault Code

Problem solving guide
103
Cancel with fault code
If a programme is cancelled and a fault code appears, e.g. Fault XXX (where XXX
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
 Switch the machine off using the  button.
 Wait approximately 10 seconds before switching the machine on again with the 
button.
 Start the previously selected programme again.
If the same message appears again:
 Make a note of the fault message.
 Switch the machine off using the  button.
 Contact Miele Service.
Please also read the notes regarding the following fault codes.
Problem Cause and remedy
Fault 403-405 A programme has been cancelled because water intake by
the machine was insufficient or severely restricted.
 Open the stopcocks fully.
 Follow the additional information given in the Check
water inlet message.
Fault 406–408 A programme was cancelled because the water flow rate is
insufficient.
 Check whether the stopcocks are fully opened.
 Please refer to the information regarding minimum flow
pressure in “Connection to the water supply” and
“Technical data”.
 Check the filters in the water supply.
 In this instance, please contact the Miele Customer
Service Department for advice.
Fault 412–414 A programme was cancelled because the water flow rate is
too high.
 Refer to the information regarding recommended
maximum flow pressure and maximum permissible static
water pressure in “Connection to the water supply” and
“Technical data”.
 In this instance, please contact the Miele Customer
Service Department for advice.
Fault440 The float switch in the base of the machine has not been
activated. The switch might be blocked.
 Remove the filter combination.
 Check the float switch to make sure it moves freely. The
float switch is located in the base of the machine behind
the spray arm.