Miele PG 8504 - Connecting the Drain Hose

Plumbing
*INSTALLATION*
121
Connecting the drain hose
- A non-return valve is incorporated into the drain system in the
machine to prevent drainage water flowing back into the machine
via the drain hose.
- The machine drainage hose should be connected to a separate
drain for the machine only. If no separate drain is available, we
recommend connecting it to a dual-chamber siphon.
- The on-site connection point, measured from the lower edge of
the machine, should be positioned at a height between 0.3m and
1.0m. If it is lower than 0.3m, the drain hose must be laid in a coil
at a height of at least 0.3m.
- The drainage system must be able to accommodate a minimum
drainage flow of 16l/min.
- The drainage hose is approx. 1.4m long and flexible with an
internal diameter of 22mm. Hose clips for the connection are
supplied.
- The drain hose must not be shortened.
- The drain hose can be extended to 4.0m in length using a
connection piece to attach a further length of hose. The drainage
length must not be longer than 4.0m.
See installation diagram supplied.