Miele PG 8504 - Operation; Selecting and Starting a Programme; Delay Start Function

Operation
55
Selecting a programme
Programme
selection buttons
 Select a programme using programme selection buttons,
or.
Programme list
 Press the button and
 use the and arrow buttons to highlight a programme and
confirm your selection with OK.
Short
Temperature
Duration
Min20
60 °C
The LED in the button selected lights up and the relevant programme
appears in the display. The LED in the Start/Stop button also starts to
flash.
Another programme can be selected at any time before a programme
has started. Once it has started, programme selection is locked.
The different programmes and their uses are described in
“Programme chart” at the end of these operating instructions.
Always select the programme depending on the type of load and
degree and type of soiling, or on infection prevention issues.
Starting a programme
 Close the door.
 Press the Start/Stopbutton.
The LED in the button will light up constantly.
Starting a
programme using
delay start
The start of a programme can be delayed (to benefit from economy
rates of electricity, for example, or to clean the wash cabinet before it
is used the next day). Starting from the programmed time, a delay
start time between 1minute and 24hours can be selected in one-
minute increments (see “Settings/Time of day”).
Delay start must be switched on (see “Settings/Delay start”).
If soiling is left to dry on the load for longer, the reprocessing result
can be adversely affected. There is also a risk of corrosion for
stainless steel items.