Miele PG 8504 - Increased Water Level; Interim Rinse

Further settings
79
Increased water
level
It is advisable to increase the water level when a lot of water is
absorbed due to the structure of the load items, in the event of heavy
soiling or when the type of stain (e.g. blood) and the process
chemicals used lead to excess foam development. The additional
volume of water depends on the type of basket or mobile unit used,
the type of stain and the load items.
...
Change volume of water
Increased water level
0.0
l
(0.0 - 1.5 l )
The volume of water can be modified in increments of 0.5l. The
possible range is shown in the bottom line of the display.
 Use the  (higher) and  (lower) arrow buttons to adjust the
volume of water.
 Press OK to save the setting.
Interim rinse
Some programmes have the option of adding an extra interim rinse
(see “Programme chart”).
...
Interim rinse
Interim rinse
No
Yes
- No
The additonal interim rinse block is deactivated.
- Yes
The additional interim rinse block is activated for all applicable
programmes.
 Select an option using the  and  arrow buttons.
 Press OK to save the setting.