Miele PG 8504 - Page 27

Commissioning
27
Commissioning
completed
Commissioning is completed when the following message is
displayed.
Set up successful
 Confirm the message with OK.
The washer-disinfector is now ready for use.
Short
Temperature
Duration
Min20
60 °C
The settings made during the commissioning process are only
adopted after a complete programme has been run.
 Select any programme, e.g.: Drain.
 Press the Start/Stop button to start the programme.
After commissioning, every programme starts with reactivation of
the water softener.
Fault420
If the programme is cancelled using Fault420, this means that all the
plumbing connections are deactivated.
 Confirm the error message with OK.
 Switch the machine off using the  button.
 Wait approximately 10 seconds before switching the machine on
again with the  button.
The commissioning procedure starts again.
 Perform commissioning and activate at least one plumbing
connection; e.g. for cold water.