Change the display language
You can use the context menu to change the language used
in the display.
This setting is stored until the washer-disinfector is switched
off by the button s (ON/OFF) or the main switch.
The language set under Settings / Language J does not
change. This means that all reports and print-outs will
continue to be produced in the system language.
^
To select the menu item
Change display language use -
e then activate it with OK.
The flag J after the words Change display language is to
help you identify an unfamiliar language.
In this case, continue to change the menu item until you
see the flag J.
^ Select the desired language and confirm with OK.
The selected language appears in the display.
^ To leave the context menu, use +C.
Context menu
19
To Next Page
Loading...
