Built-in printer (Option)
Replacing the paper roll
When the red indicator light on the front
panel of the printer lights up, the paper
roll needs to be replaced. The amount
of paper on the roll should be checked
regularly. To do so:
^
Open the front panel of the printer by
the upper edge and flip down.
When the red indicator light comes on,
replace the paper roll.
To do so:
^ Open the front panel of the printer by
the upper edge and flip down.
^ Remove the paper roll and spindle
from the holder, fit the new roll onto
the spindle and install them back into
the printer.
^ Guide the paper up and over the
paper transport roller (slit behind the
ribbon cartridge). Press the green
paper transport button until the paper
re-emerges above the ribbon
cartridge.
^
Guide the paper through the slit in
the front panel. Shut the panel.
Replacement paper rolls, 58 mm (2.25")
wide / outer diameter approx. 50 mm
(2"), can be obtained from Miele
Customer Service or your dealer.
Replacing the ribbon cartridge
^
Open the front panel of the printer by
the upper edge and flip down.
^
The ribbon cartridge is above the
paper roll. Pull it forward and out of
the holder and replace it with a new
one. Be sure to guide the paper
between the ribbon and the cartridge
housing.
^
On the right, turn the small wheel for
manual ribbon transport clockwise
until the ribbon is taut.
^
Guide the paper through the slit in
the front panel. Shut the panel.
Replacement ribbon cartridges can be
obtained from Miele Customer Service
or your dealer.
Maintenance
51
To Next Page
