Main switch
The main switch disconnects the
washer-disinfector from the power
supply.
^
Turn the main switch to I-ON.
Once the start procedure is completed,
the washer-disinfector is ready to
operate.
The following message may appear:
Fault 2218: "New power frequency
60 Hz Flow rate automatically
adjusted" or "New power frequency
50Hz Flow rate automatically
adjusted". During the start procedure,
the Profitronic detected a different
network frequency and adjusted the
flow rate of the dispensing pump
accordingly. Before operation, you
will need to check whether the
change in power frequency was
caused by a fault in the power
supply.
If so, incorrect amounts of
processing chemicals would be
dispensed during the program.
The fault message can only be
confirmed in operating level D and in
service mode.
How to switch on
^
Hold down the s (ON/OFF) button
for at least 1.5 s.
The actuating time for the s
(ON/OFF) button can be set up to a
maximum of 10 s (see "Programming
manual" for the section on "System
functions / On/Off button activation
time").
Depending on the set operating level,
the following will appear in the display:
Operating
levels
Displayed
A and B A list of approved
programs.
C Instructions for Auto-
matic mobile unit
recognition.
D Select from:
– Program overview
– Programming
–
Settings J.
If the washer-disinfector is not in use,
the display automatically switches off
after approx. 10 min.
To turn the display back on, press
any button.
Operating the machine
37
To Next Page
Loading...
